Hardware automatic processing equipment Maintenance method

2023-02-28

Hardware Automatic Processing Equipment Maintenance method

1. Pay careful attention to a complete work cycle to see if all the movements are smooth.

2. Before starting the machine, check the change of lubricating oil level of each oil cup, and need to be supplemented in advance.

3. Remove the wood chips and dust on the machine.

4. Remove the debris in the air filter of the pneumatic triplet (main air source).

5. After each work, clean up the mechanical parts, clean up the filter barrel of the vacuum motor and clean up the filter of the electric box.

6. The operator must be cleaned to the tool, chuck and pressure cap when the tool is on! If this detail is done properly, the life of the spindle motor can be greatly extended!

7. Check whether the pneumatic control system pressure is normal, there is no air leakage, keep the pipeline smooth.

8. Check whether the cooling fan of the electrical cabinet is working normally, and clean the dust on the fan and filter in time.

9. Keep the knife magazine clean, check whether the knife magazine is running normally before starting the machine, there is no disorderly knife, falling knife phenomenon, the knife handle Latin should be free of loose hair pulling.

10. Clean the wood chips and dust around the equipment, keep the surrounding site neat and tidy, and stack the workpieces neatly.

Previous: The principle of hardware automatic processing equipment

Next: What are the common types of hardware automatic processing equipment?